Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Keyless Entry Control Module
INSTALLATION
Install each part in the reverse order of removal.
Tightening torque:
Keyless entry control module: 13 N·m (1.33 kgf-m, 9.6 ft-lb)
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL"&g ...
Other materials:
Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...
Removal
EXTERIOR BODY PANELS > Front Sealing CoverREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the trim panel - front door. Door Trim > REMOVAL">3. Remove the sealing cover - front door.CAUTION:• Caref ...
Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...
