Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > IG Relay1 (Push Button Start)
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
3. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
4. Release the lock and remove the fuse holder.
5. Remove the relay & fuse box.
(1) Disconnect the connector.
(2) Remove the bolts and nuts, and remove the relay & fuse box.
6. Remove IG relay 1 (push button start) (A) from the relay holder.
Inspection
SECURITY AND LOCKS > IG Relay1 (Push Button Start)INSPECTIONRefer to “CHECK RELAY” in “Relay and Fuse”. Relay and Fuse > INSPECTION"> ...
Installation
SECURITY AND LOCKS > IG Relay1 (Push Button Start)INSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIR ...
Other materials:
Dtc b16f9 door sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F9 DOOR SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Front door impact sensor (RH) is misinstalled.• Airbag control module is faulty.CAUTION:Before ...
Engine electrical system Wiring diagram
WIRING SYSTEM > Engine Electrical SystemWIRING DIAGRAM1. WITHOUT PUSH BUTTON START2. WITH PUSH BUTTON START ...
Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...
