Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Wiring diagram

SECURITY AND LOCKS > Security System

WIRING DIAGRAM

Refer to “Security System” in the wiring diagram.

Model without push button start: Security System > WIRING DIAGRAM">

Model with push button start: Security System > WIRING DIAGRAM">

Electrical specification
SECURITY AND LOCKS > Security SystemELECTRICAL SPECIFICATIONRefer to “Control Module I/O Signal” of “BODY CONTROL SYSTEM (DIAGNOSTICS)” section. Control Module I/O Signal & ...

Inspection
SECURITY AND LOCKS > Security SystemINSPECTION1. BASIC DIAGNOSTIC PROCEDURESTEPCHECKYESNO1.INITIAL CHECK.Check the keyless entry system or keyless access system operation.Does the keyless entry sys ...

Other materials:

Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...

Tire pressure warning light is 25 times blinking and turn on
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternTIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ONDetecting condition:• Defective TPMS & keyless entry CM or TPMS CM• Defective harness• Transm ...

Welcome screen and Good-bye screen
When the driver's door is opened and closed after unlocking the door, the welcome screen will appear on the multi information display for approximately 20 seconds. When the ignition switch is turned to the "LOCK"/"OFF" position, the multi information display gradually turns off (Good-bye s ...

© 2016-2026 Copyright www.sucross.com