Subaru Crosstrek Service Manual: Removal
SECURITY AND LOCKS > Front Inner Remote
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the screw, and remove the remote assembly - door.
CAUTION:
The remote assembly - door is tightened with the plate. Be careful not to drop or damage the part.
Inspection
SECURITY AND LOCKS > Front Inner RemoteINSPECTIONCheck if the remote handle operates normally.• If the lever is faulty, replace the remote handle.• If the cable is deformed, replace the ...
Installation
SECURITY AND LOCKS > Front Inner RemoteINSTALLATION1. Before installation, check the following items.• Cable is free from deformation such as fray.• Grease is applied sufficiently to ca ...
Other materials:
Dtc c1424 ecm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1424 ECMDTC detecting condition:ECM malfunctioningTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.STEPCHECKYESNO1.CHECK E ...
Replacement of wiper blades
Contamination such as grease, wax residues, insects, or road debris on the windshield
or wiper blades of your Subaru Ascent can lead to uneven wiping, jerky motion, and
visible streaks across the glass. If these issues persist even after using the washer
system, thoroughly clean the windshield ...
Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...
