Subaru Crosstrek Service Manual: Inspection
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator Assembly
INSPECTION
1. LATCH
Check if the latch operates normally.
If the cable is faulty, replace the latch & actuator assembly - rear.
2. ACTUATOR
1. Check door lock operation
Check the door lock operation when battery voltage is applied between the terminals of actuator.
Terminal No. | Inspection conditions | Specification |
4 (+) — 1 (−) | Apply battery voltage. | LOCK |
1 (+) — 4 (−) | UNLOCK |
2. If it does not operate properly as a result of inspection, replace the latch & actuator assembly - rear.
Removal
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL& ...
Other materials:
Procedure
LIGHTING SYSTEM > Auto Headlight Beam Leveler SystemPROCEDUREWhen parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.NOTE:Before performing initialization or reinitialization, check the following:• ...
Dtc p0327 knock/combustion vibration sensor 1 circuit low bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0327 KNOCK/COMBUSTION VIBRATION SENSOR 1 CIRCUIT LOW BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Poor driving performance• Knocking occursCAUTI ...
Electrical component location Location
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Headlight ASSY– Headlight beam leveler actuator(4)Headlight relay (Hi)(7)Combination meter(2)Rear vehicle height sensor(5)Body integrated unit(8)Fuse 10 A (auto headlight beam leveler CM)(3)Headlight rel ...
