Subaru Crosstrek Service Manual: Procedure

1. METHOD FOR STOPPING KEYLESS ACCESS SYSTEM FUNCTION BY OPENING/CLOSING DOORS

1. Check that the vehicle status is as follows:

• Ignition switch OFF

• One window is completely open

• Keyless access system is activated (or disabled if re-activating)

2. Sit in the driver’s seat with the door closed and press the door lock switch to UNLOCK once.

3. Open the driver’s door within five seconds.

4. Within 5 seconds, with the driver’s door opened, slowly press the door lock switch to UNLOCK twice.

5. Within 10 seconds after finishing step 4), perform the closing > opening operation of the driver’s door twice.

6. Within 10 seconds after finishing step 5), with the driver’s door opened, slowly press the door lock switch to UNLOCK twice.

7. Within 10 seconds after finishing step 6), perform the closing > opening operation of the driver’s door once.

8. Within five seconds after finishing step 7), close the drivers door.

NOTE:

• Perform the same procedures to re-activate the keyless access system from the disabled condition.

• In step 4) and step 6), press the door lock switch completely. The function may not work properly if the switch is pressed shortly.

1. Open the driver’s door and press the door lock knob forward (in the LOCK direction).

2. Press the lock button and the trunk/rear gate button of the access key simultaneously for at least five seconds.

3. A buzzer sounds for two seconds and the function stops.

NOTE:

Perform the same procedures to re-activate the keyless access system from the disabled condition.

Operation

General description

Other materials:

Sonar Audible Alarm function
In the Subaru Ascent, the Reverse Automatic Braking (RAB) system is supported by an advanced sonar audible alert function designed to enhance driver awareness. When the system detects a potential obstacle while reversing, it emits warning sounds in three distinct intensity levels, helping the ...

Light control switch
CAUTION Extended use of vehicle lighting while the engine is not running may lead to battery discharge in the Subaru Ascent. Before leaving your Subaru Ascent unattended, ensure that the light control switch is set to the OFF position. Even though the lights may automatically turn off ...

Dtc b2a01 tel1 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A01 TEL1 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the followings continues for 5 seconds or more.• TEL1 impedance is more than 1 M?. (Deta ...