Subaru Crosstrek Service Manual: Installation

1. Before installation, check the following items.

• Cable is free from deformation such as fray.

• Grease is applied sufficiently to cable joints.

If grease is insufficient, add it as necessary before assembling the cable.

• If the lever is faulty, replace the rear inner remote handle.

2. Install each part in the reverse order of removal.

Removal

Rear lock button

Other materials:

Inspection
PERIODIC MAINTENANCE SERVICES > Front & Rear Differential Gear OilINSPECTION1. FRONT DIFFERENTIAL (MT MODEL)Front differential gear oil of MT model lubricates the transmission and differential together. Refer to “Transmission Gear Oil” for inspection procedures. Transmission Gear ...

Dtc p2402 evap system leak detection pump control circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2402 EVAP SYSTEM LEAK DETECTION PUMP CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...

Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...