Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc p000c "a" camshaft position slow response bank 2

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P000C "A" CAMSHAFT POSITION SLOW RESPONSE BANK 2

NOTE:

For the diagnostic procedure, refer to DTC P0021. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0021 "A" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2">

1. OUTLINE OF DIAGNOSIS

NOTE:

For the detection standard, refer to P000A. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P000A "A" CAMSHAFT POSITION SLOW RESPONSE BANK 1">

Dtc p000b "b" camshaft position slow response bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000B "B" CAMSHAFT POSITION SLOW RESPONSE BANK 1NOTE:For the diagnostic procedure, refer to DTC P00 ...

Dtc p000d "b" camshaft position slow response bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000D "B" CAMSHAFT POSITION SLOW RESPONSE BANK 2NOTE:For the diagnostic procedure, refer to DTC P00 ...

Other materials:

Head restraint height adjustment
Head restraint Release button To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head ...

Inspection
SECURITY AND LOCKS > Front Door Latch and Door Lock Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If the cable or rod is faulty, replace the latch & actuator assembly - front.2. LOCK ACTUATORPreparation tool:Circuit tester1. Check door lock operationCheck the door lo ...

Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the crimped section of axle nut.(2) Remove the axl ...

© 2016-2025 Copyright www.sucross.com