Subaru Crosstrek Service Manual: Dtc p0303 cylinder 3 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P0303 CYLINDER 3 MISFIRE DETECTED
NOTE:
For the diagnostic procedure, refer to DTC P0304. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0304 CYLINDER 4 MISFIRE DETECTED">
1. OUTLINE OF DIAGNOSIS
NOTE:
For the detection standard, refer to DTC P0301. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0301 CYLINDER 1 MISFIRE DETECTED">
Dtc p0302 cylinder 2 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0302 CYLINDER 2 MISFIRE DETECTEDNOTE:For the diagnostic procedure, refer to DTC P0304. Diagnostic Procedure ...
Dtc p0304 cylinder 4 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0304 CYLINDER 4 MISFIRE DETECTEDDTC detecting condition:• Detected when two consecutive driving cycles ...
Other materials:
Assembly
CLUTCH SYSTEM > Master CylinderASSEMBLY1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.Grease:SILICONE GREASE G-40M or equivalent2. Assemble in the reverse order of disassembly.Tightening torque:10 N·m (1.0 kgf-m, 7.4 ft-lb) ...
Adjustment
WIPER AND WASHER SYSTEMS > Rear Wiper ArmADJUSTMENT1. Operate the rear wiper once.2. Align the blade assembly - rear wipe with the marking on the glass.3. If the wiper blade is not aligned with the point mark, perform the removal of the rear wiper to align with the marking. Rear Wiper Arm > R ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Hose and PipeINSTALLATIONCAUTION:• If the hose and pipe have been replaced, add an appropriate amount of compressor oil to the compressor. Compressor Oil > ADJUSTMENT">• Replace the O-rings with new parts, and then apply compresso ...
