Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc p000d "b" camshaft position slow response bank 2

ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P000D "B" CAMSHAFT POSITION SLOW RESPONSE BANK 2

NOTE:

For the diagnostic procedure, refer to DTC P0024. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0024 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 2">

1. OUTLINE OF DIAGNOSIS

NOTE:

For the detection standard, refer to P000B. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P000B "B" CAMSHAFT POSITION SLOW RESPONSE BANK 1">

Dtc p000c "a" camshaft position slow response bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P000C "A" CAMSHAFT POSITION SLOW RESPONSE BANK 2NOTE:For the diagnostic procedure, refer to DTC P00 ...

Dtc p0010 "a" camshaft position actuator control circuit/open bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0010 "A" CAMSHAFT POSITION ACTUATOR CONTROL CIRCUIT/OPEN BANK 1DTC detecting condition:Immediately ...

Other materials:

Hill start assist warning light does not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternHILL START ASSIST WARNING LIGHT DOES NOT COME ONDetecting condition:Defective combination meterTrouble symptom:When the ignition switch is turned to ON (engine OFF), hill start assist warning light does not illuminat ...

Adjustment
SECURITY AND LOCKS > Front Hood Lock AssemblyADJUSTMENT1. Loosen the bolt, and adjust the lock assembly - front hood while moving it up and down.2. After adjustment, tighten the bolts securely.Tightening torque:Refer to “COMPONENT” of “General Description”. General Descri ...

Dtc p2610 ecm/pcm engine off timer performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2610 ECM/PCM ENGINE OFF TIMER PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Cle ...

© 2016-2026 Copyright www.sucross.com