Subaru Crosstrek Service Manual: Continuously variable transmission(tr580)
- Air breather hose
- Automatic transmission assembly
- Awd on/off switching mode
- Control valve body
- Converter case
- Cvtf
- Cvtf cooler (with warmer function)
- Cvtf filter
- Differential gear oil
- Differential side retainer oil seal
- Drive pinion shaft assembly
- Drive plate
- Extension case
- Extension case oil seal
- Forward clutch assembly
- Front differential assembly
- General description
- Inhibitor switch
- Oil pan and strainer
- Oil pump
- Oil pump chain
- Parking pawl
- Preparation for overhaul
- Primary pulley and secondary pulley
- Primary speed sensor
- Reduction drive gear
- Reduction driven gear
- Reverse brake assembly
- Secondary pressure sensor
- Secondary speed sensor
- Torque converter assembly
- Transfer clutch
- Transfer driven gear
- Transmission case
- Transmission control device
- Transmission control module (tcm)
- Transmission harness
- Transmission mounting system
- Turbine speed sensor
- Variator chain
- Diagnostics with phenomenon Inspection
- Road test Inspection
- Secondary pressure (line pressure) test Inspection
- Stall test Inspection
- Time lag test Inspection
- Transfer clutch pressure test Inspection
Subaru select monitor Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. REA ...
Other materials:
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Front Differential AssemblyASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Install the washer and differential bevel gear into the differential case (RH).2. Install the differential bevel pinions into differential case (RH) and install the pinion shaft.(A)Pinio ...
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyDISASSEMBLY1. Put vinyl tape around main shaft spline to protect the oil seal from damage. Then pull out the oil seal and needle bearing by hand.2. Remove the lock nut and lock washer.NOTE:Flatten the lock nut tab before removing the ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...
