Subaru Crosstrek Service Manual: Primary speed sensor

Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Pulley and Secondary PulleyINSTALLATION1. Select shims for pulley alignment. Primary Pulley and Secondary Pulley > ADJUSTMENT">2. Ins ...

Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check ...

Other materials:

Removal
WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)REMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Release the clips, and remove the cover assembly - steering UPR.(2) Remove the screws by turning the steering wheel to right and left.( ...

Dtc p2751 intermediate shaft speed sensor "c" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2751 INTERMEDIATE SHAFT SPEED SENSOR "C" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Shifting shock is felt.• Acceler ...

Automatic headlight beam leveler warning light (models with HID headlights)
This light illuminates when the automatic headlight beam leveler does not operate normally. If this light illuminates while driving or does not turn off approximately 3 seconds after turning the ignition switch to the "ON" position, have your vehicle inspected at your SUBARU dealer. Fr ...