Subaru Crosstrek Service Manual: Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
ADJUSTMENT
1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
Reverse shifter lever | ||
Part No. | Mark | Contents |
32820AA070 | 7 | Far from case wall |
32820AA080 | 8 | Standard |
32820AA090 | 9 | Closer to case wall |
2. Select the appropriate adjusting washer from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
Adjusting washer | |
Part No. | Thickness mm (in) |
803020151 | 0.4 (0.016) |
803020152 | 1.1 (0.043) |
803020153 | 1.5 (0.059) |
803020154 | 1.9 (0.075) |
803020155 | 2.3 (0.091) |
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the b ...
Other materials:
Dtc u0422 invalid data received from body control module
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEDetected when CAN data from BIU is abnormal.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCE ...
Disassembly
GLASS/WINDOWS/MIRRORS > Outer Mirror AssemblyDISASSEMBLYCAUTION:When removing the mirror - repair, be careful not to damage the back surface of mirror - repair with a flat tip screwdriver.1. Operate the remote control mirror switch to face the mirror - repair upward.2. Disconnect the ground cable ...
Removal
LIGHTING SYSTEM > Glove Box LightREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket.(3) Release the stoppers and remove the pocket assembly by pulling it t ...
