Subaru Crosstrek Service Manual: Inspection

Subaru Crosstrek Service Manual / Continuously variable transmission(tr580) / Transmission control device / Inspection

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Device

INSPECTION

Make sure that the manual plate and detent spring are not worn or otherwise damaged.

Removal

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control DeviceREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove ...

Other materials:

Hill start assist warning light does not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternHILL START ASSIST WARNING LIGHT DOES NOT COME ONDetecting condition:Defective combination meterTrouble symptom:When the ignition switch is turned to ON (engine OFF), hill start assist warning light does not illuminat ...

Removal
LIGHTING SYSTEM > Spot Map LightREMOVAL1. MODELS WITHOUT EyeSight1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - map.CAUTION:When using a flat tip screwdriver, use an appropriate sized tool for the insertion opening, apply protective tape or cloth around ...

Preparation tool
DRIVE SHAFT SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONPART NO.DESCRIPTIONREMARKS20099PA010INSTALLER & REMOVER• Used for replacing the rear bushing of rear axle housing.• Used together with BUSHING REMOVER (20099FG000).20099FG000BUSHING REMOVER• U ...