Subaru Crosstrek Service Manual: Inspection

Check the following items.

• Check the oil pump for damage and wear.

• Rotate the oil pump by hand, and check that it rotates smoothly.

1. Measure the secondary pressure. Secondary Pressure (Line Pressure) Test > INSPECTION">

2. Remove the oil pan and oil strainer. Oil Pan and Strainer > REMOVAL">

3. Check oil strainer for clogging.

When oil strainer has no clogging, replace the oil pump.

Oil pump

Removal

Other materials:

Dtc p0458 evap system (cpc) purge control valve "a" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0458 EVAP SYSTEM (CPC) PURGE CONTROL VALVE "A" CIRCUIT LOWDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing ...

Clear memory mode Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» ...

Dtc u0126 lost communication with steering angle sensor module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0126 LOST COMMUNICATION WITH STEERING ANGLE SENSOR MODULEDTC DETECTING CONDITION:No data is received from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING ...