Subaru Crosstrek Service Manual: Continuously variable transmission(tr580)
- Air breather hose
- Automatic transmission assembly
- Awd on/off switching mode
- Control valve body
- Converter case
- Cvtf
- Cvtf cooler (with warmer function)
- Cvtf filter
- Differential gear oil
- Differential side retainer oil seal
- Drive pinion shaft assembly
- Drive plate
- Extension case
- Extension case oil seal
- Forward clutch assembly
- Front differential assembly
- General description
- Inhibitor switch
- Oil pan and strainer
- Oil pump
- Oil pump chain
- Parking pawl
- Preparation for overhaul
- Primary pulley and secondary pulley
- Primary speed sensor
- Reduction drive gear
- Reduction driven gear
- Reverse brake assembly
- Secondary pressure sensor
- Secondary speed sensor
- Torque converter assembly
- Transfer clutch
- Transfer driven gear
- Transmission case
- Transmission control device
- Transmission control module (tcm)
- Transmission harness
- Transmission mounting system
- Turbine speed sensor
- Variator chain
- Diagnostics with phenomenon Inspection
- Road test Inspection
- Secondary pressure (line pressure) test Inspection
- Stall test Inspection
- Time lag test Inspection
- Transfer clutch pressure test Inspection
Subaru select monitor Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. REA ...
Other materials:
Dtc p2101 throttle actuator "a" control motor circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2101 THROTTLE ACTUATOR "A" CONTROL MOTOR CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance&bull ...
Clear memory mode Operation
IMMOBILIZER (DIAGNOSTICS) > Clear Memory ModeOPERATIONNOTE:For detailed operation procedures, refer to “Application help”.1. ECM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main ...
Menu screens
Pull the "
/SET" switch to enter the menu
screens when all of the following conditions
are satisfied.
The vehicle has been completely
stopped.
The select lever is in the "P" position.
The menu screen entering screen is
selected.
The "
" information reminder is off.
Th ...