Subaru Ascent 2018-2026 Owner's Manual: Starting and operating
- Fuel
- State emission testing (U.S. only)
- Preparing to drive
- Starting and stopping the engine (models without push-button start system)
- Starting and stopping engine (models with push-button start system)
- Remote engine start system (dealer option)
- Remote engine starter transceiver (fob)
- Alternate operation method for models with "keyless access with push-button start system"
- Entering the vehicle while it is running via remote start (models without "keyless access with push-button start system")
- System maintenance
- Continuously variable transmission
- Power steering
- Braking
- ABS (Anti-lock Brake System)
- Electronic Brake Force Distribution (EBD) system
- Vehicle Dynamics Control system
- X-MODE
- Tire pressure monitoring system (TPMS) (U.S.-spec. models)
- Parking your vehicle
- Hill start assist system
- BSD/RCTA
- System features
- System operation
- BSD/RCTA approach indicator light/warning buzzer
- BSD/RCTA OFF indicator
- BSD/RCTA warning indicator
- Handling of radar sensors
- Reverse Automatic Braking (RAB) system
- Reverse Automatic Braking (RAB) system overview
- Operating conditions
- Sonar Audible Alarm function
- Automatic Braking function operation
- Reverse Automatic Braking (RAB) system ON/OFF setting
- RAB warning indicator
- Driver Monitoring System
Rear view camera
In the Subaru Ascent, the rear view camera is mounted on the rear gate and is
designed to assist the driver during reversing maneuvers. When the ignition is switched
to the "ON" posi ...
Fuel
CAUTION
In the Subaru Ascent, using low-quality fuel or unsuitable fuel additives
may negatively affect engine performance and potentially cause damage to the
fuel system.
At certain fuel ...
Other materials:
Disassembly
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelDISASSEMBLY1. CROSSTREK MODEL1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)2. Release the claws and remove the screws, then detach the cover - spoke.3. Remove connector and screw, a ...
Electrical specification
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Models without EyeSightNOTE:• Terminal numbers in VDCCM&H/U connector (on the control module side) are shown in the figure.• When the connector is removed from the VDCCM&H/U ...
Control screen
PHONE (Menu) screen
PHONE (Dialpad) screen
Open the "Incoming Calls" screen.
Refer to "By incoming calls"
Open the "Outgoing Calls" screen.
Refer to "By outgoing calls"
Open the "Contacts" screen. Refer to
"By contacts list
Open the dialpad screen. Refer to "By
Dialpad
O ...
