Subaru Crosstrek Service Manual: Clear memory mode Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Telematics» and then select «Enter».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
For detailed operation procedures, refer to “Application help”.
Check list for interview Check
TELEMATICS SYSTEM (DIAGNOSTICS) > Check List for InterviewCHECK1. CHECK LIST FOR INTERVIEW• Inspect the following items regarding the vehicle’s state.• Print out this page for int ...
Electrical component location Location
TELEMATICS SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Data link connector(4)Data communication module (DCM)(6)Instrument panel speaker(2)GPS antenna(5)Audio or navigation(7)Airb ...
Other materials:
Removal
LUBRICATION(H4DO) > Oil Level SwitchREMOVAL1. Open the front hood, and make alignment marks (A) on the front hood striker and the front hood using a marker pen.2. Remove the front hood striker from the front hood.3. Change the front hood stay position from (A) to (B), and completely open the fron ...
Dtc p1531 battery current sensor circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1531 BATTERY CURRENT SENSOR CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION&q ...
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
