Subaru Crosstrek Service Manual: Power assisted system (power steering) (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc c2552 motor relay
- Dtc u1120 lost communication with autostart stop control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc c2511 torque sensor main
- Dtc c2512 torque sensor sub
- Dtc c2513 torque sensor much tolerance
- Dtc c2514 torque sensor power supply
- Dtc c2521 motor malfunction
- Dtc c2522 resolver sensor
- Dtc c2531 control module cpu
- Dtc c2532 control module peripheral circuit
- Dtc c2533 control module board temperature sensor
- Dtc c2541 vehicle dynamics control module vehicle speed sensor
- Dtc c2543 error passive
- Dtc c2551 power supply relay
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
- General description
- Steering warning light
- Subaru select monitor
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Electrical component location Location
- Inspection mode Procedure
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
Wheel bearing Inspection
PERIODIC MAINTENANCE SERVICES > Wheel BearingINSPECTION1. FRONT WHEEL BEARINGNOTE:Inspect the condition of front wheel bearing grease.1. Jack-up the front side of vehicle.2. While holding the front ...
Other materials:
Operation
VEHICLE DYNAMICS CONTROL (VDC) > VDC Sequence ControlOPERATION1. While the VDC sequence control is performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve is operated.2. VDC sequence control can be started by S ...
Dtc p0038 a/f / o2 heater control circuit high bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0038 A/F / O2 HEATER CONTROL CIRCUIT HIGH BANK 1 SENSOR 2DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear ...
Assembly
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Intake ManifoldASSEMBLY1. Install the fuel pipe and cap to the intake manifold.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the fuel delivery pipe to the intake manifold.CAUTION:• Check that there is no damage or dust on the quick c ...
