Subaru Crosstrek Service Manual: Steering warning light does not go off

Detecting condition:

• Defective combination meter

• Open circuit of harness

1.CHECK DTC.

Read the DTC of the power steering control module using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

STEERING Warning Light > STEERING WARNING LIGHT DOES NOT GO OFF">Go to Step 2.

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure">

Is a DTC related to CAN communication detected?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Check the combination meter. Combination Meter System > INSPECTION">

Steering warning light does not come on

Subaru select monitor

Other materials:

Removal
EXTERIOR/INTERIOR TRIM > Console BoxREMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:On CVT models, shift the select lever into “N” before disconnecting the battery ground cable.2. Remove the console box assembly.(1) Release the claws, and then remove the boot - ...

Removal
EXTERIOR/INTERIOR TRIM > Rear Quarter TrimREMOVAL1. CROSSTREK MODELCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system sat ...

Assembly
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxASSEMBLY1. Install the tie-rod into rack.Tightening torque:90 N·m (9.18 kgf-m, 66.4 ft-lb)NOTE:Check the mating face of rack and tie-rod for foreign matter such as dust etc.2. Apply a coat of grease to the tie-rod groo ...