Subaru Crosstrek Service Manual: Clear memory mode Operation
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Clear Memory Mode
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Power Steering».
5. On «Select Function» display, select «DTC».
6. On «DTC» display, select «Clear Memory».
NOTE:
• Before performing memory clear, check the current data, and if there are any data of DTC, trouble status information, overheating protection intervention history, IGN count from overheating protection and assist limit history, save them.
• For detailed operation procedures, refer to “Application help”.
Check list for interview Check
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following items regarding condition of the vehicle.1. TROUBLE STATUSPhenomenon of the vehicle Steering ...
Electrical component location Location
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Steering gearbox(3)STEERING warning light(5)VDCCM&H/U(2)Power steering control module(4)Engine con ...
Other materials:
Dtc p0757 shift solenoid "b" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0757 SHIFT SOLENOID "B" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Vibration occurs at shift change.& ...
Inspection
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. Repair or replace if defective.• DOJ (Double Offset Joint):Check for seizure, corrosion, damage, wear and excessive play.• BJ (Bell Joint):Check for seizure, corrosion, damage and e ...
Certification for the Hands-free system
This device complies with Part 15 of FCC
Rules and Industry Canada's licenceexempt
RSSs. Operation is subject to
the following two conditions: (1) This
device may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause u ...
