Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc c2552 motor relay
- Dtc u1120 lost communication with autostart stop control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc c2511 torque sensor main
- Dtc c2512 torque sensor sub
- Dtc c2513 torque sensor much tolerance
- Dtc c2514 torque sensor power supply
- Dtc c2521 motor malfunction
- Dtc c2522 resolver sensor
- Dtc c2531 control module cpu
- Dtc c2532 control module peripheral circuit
- Dtc c2533 control module board temperature sensor
- Dtc c2541 vehicle dynamics control module vehicle speed sensor
- Dtc c2543 error passive
- Dtc c2551 power supply relay
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
Wiring diagram
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAM(1)Battery(5)Engine control module (ECM)(9)Torque sensor (main & sub)(2)Ignition switch(6)Power ste ...
Dtc c2552 motor relay
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2552 MOTOR RELAYTROUBLE SYMPTOM:• The steering wheel operation feels heavy.& ...
Other materials:
Dtc b2a00 vin reading
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A00 VIN READINGDiagnosis start condition:When ignition switch is ON.DTC detecting condition:When ignition switch is ON, VIN information (CAN) sent from ECM cannot be read.Trouble symptom:• Telemat ...
Keyless access with push-button start system
The Subaru Ascent may also be equipped with an advanced keyless access system
featuring push-button start, enhancing both convenience and security.
Access key fob (main)
Access key fob (sub)
Key number plate
The Subaru Ascent keyless access system enables the following functions whe ...
Removal
EXTERIOR/INTERIOR TRIM > Front BumperREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front.(1) Remove the screw and clips, and turn over the mud guard - front.(2) Disconnect the connectors of the left and right fog light assembly - front. (Model with ...
