Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0100 lost communication with ecm/pcm a
- Dtc u1433 invalid data received from eyesight
- Dtc u0101 lost communication with tcm
- Dtc u1232 lost communication with rear/side radar control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0126 lost communication with steering angle sensor module
- Dtc u0131 lost communication with power steering control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc u0156 lost communication with information center "a"
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0164 lost communication with hvac control module
- Dtc u0327 software incompatibility with vehicle security control module
- Dtc u0401 invalid data received from ecm/pcm a
- Dtc u0402 invalid data received from tcm
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0420 invalid data received from power steering control module
- Dtc u0422 invalid data received from body control module
- Dtc u0423 invalid data received from instrument panel cluster control module
- Dtc u0424 invalid data received from hvac control module
- Dtc u0427 invalid data received from vehicle security control module
- Dtc u0073 control module communication bus off
- Dtc u0428 invalid data received from steering angle sensor module
- Dtc u0452 invalid data received from restraints control module
- Dtc u1120 lost communication with autostart stop control module
- Dtc u1201 can-hs counter abnormal
- Dtc u1235 lost communication with eyesight
Wiring diagram
LAN SYSTEM (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “CAN Communication System” in the wiring diagram. CAN Communication System > WIRING DIAGRAM"> ...
Dtc u0100 lost communication with ecm/pcm a
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”DTC DETECTING CONDITION:No data is received from ECM.TROUB ...
Other materials:
Base display audio set (if equipped)
Power/VOLUME knob
Eject button
AUDIO/TUNE knob
HOME button
APPS button
Display
SEEK/TRACK buttons
The audio set will operate only when the
ignition switch is in the "ACC" or "ON"
position.
Power and audio controls: refer to
"Basic operation"
SUBARU STARLINK (if equipp ...
Note
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Conditioning SystemNOTEFor procedure of each component in the air conditioning system, refer to the respective section.• Blower motor unit assembly: Blower Motor Unit Assembly">• Blower motor: Blower Motor">• Power ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the clips, and remove the under cover assembly - passenger.3. Remove the blower - motor.(1) Disconnect the connector.(2) Remove the screws and detach the blower - m ...
