Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Wiring diagram

LAN SYSTEM (DIAGNOSTICS) > Control Module I/O Signal

WIRING DIAGRAM

Refer to “CAN Communication System” in the wiring diagram. CAN Communication System > WIRING DIAGRAM">

Electrical specification
LAN SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Body integrated unitFor I/O signals of the body integrated unit, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). Con ...

Diagnostic procedure with diagnostic trouble code (dtc)
...

Other materials:

Disassembly
CLUTCH SYSTEM > Master CylinderDISASSEMBLY1. Remove the straight pin and nipple.(A)Nipple(B)Straight pin2. Remove the oil seal.(A)Oil seal3. Move the seat towards the rear.(A)Seat(B)Master cylinder4. Remove the piston stop ring.CAUTION:When removing the piston stop ring, be careful to prevent the ...

Dtc p0103 mass or volume air flow sensor "a" circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0103 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Engine stall• Poor driving performanc ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Shifter Fork and RodINSTALLATION1. Install the check ball spring and check ball to the reverse fork rod arm, and press in the ST.ST 399411700ACCENT BALL INSTALLER2. Install the reverse fork rod through the hole on the rear of the transmission case. P ...

© 2016-2026 Copyright www.sucross.com