Subaru Crosstrek Service Manual: Disassembly
CLUTCH SYSTEM > Master Cylinder
DISASSEMBLY
1. Remove the straight pin and nipple.
(A) | Nipple |
(B) | Straight pin |
2. Remove the oil seal.
(A) | Oil seal |
3. Move the seat towards the rear.
(A) | Seat |
(B) | Master cylinder |
4. Remove the piston stop ring.
CAUTION:
When removing the piston stop ring, be careful to prevent the rod, washer, piston and return spring from popping out.
Removal
CLUTCH SYSTEM > Master CylinderREMOVALCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe c ...
Inspection
CLUTCH SYSTEM > Master CylinderINSPECTIONIf any damage, deformation, wear, swelling, rust or other faults are found on the cylinder, piston, push rod, nipple, return spring, bleeder screw, seat or ...
Other materials:
Wiring diagram
SECURITY AND LOCKS > Push Button Start SystemWIRING DIAGRAMFor wiring diagrams related to the push button start system (ignition change), refer to the following items.• Keyless access system: Keyless Access System > WIRING DIAGRAM">• Push button start system: Push Button ...
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...
Dtc c0044 tcm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0044 TCM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from TCM.Trouble symptom:• ABS does not operate.• VDC does not operate.• EyeSight does not operate.STEPC ...
