Subaru Crosstrek Service Manual: Inspection
CLUTCH SYSTEM > Master Cylinder
INSPECTION
If any damage, deformation, wear, swelling, rust or other faults are found on the cylinder, piston, push rod, nipple, return spring, bleeder screw, seat or hose, replace the faulty part.
(A) | Master cylinder body |
(B) | Seat |
(C) | Return spring |
(D) | Piston |
(E) | Piston stop ring |
(F) | Push rod ASSY |
Disassembly
CLUTCH SYSTEM > Master CylinderDISASSEMBLY1. Remove the straight pin and nipple.(A)Nipple(B)Straight pin2. Remove the oil seal.(A)Oil seal3. Move the seat towards the rear.(A)Seat(B)Master cylinder ...
Installation
CLUTCH SYSTEM > Master CylinderINSTALLATION1. Install the master cylinder to the body, and connect the clutch pipe and the tank hose.Tightening torque:T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)T2: 1 ...
Other materials:
Before driving your vehicle
Before entering the vehicle, remove any
snow or ice from your shoes because that
could make the pedals slippery and
driving dangerous.
While warming up the vehicle before
driving, check that the accelerator pedal,
brake pedal, and all other controls operate
smoothly.
Clear away ice and sno ...
Removal
SECURITY AND LOCKS > Starter Cut RelayREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait fo ...
Brake system warning light (red)
The
light illuminates with the parking
brake applied while the ignition switch is
in the "ON" position. It turns off when the
parking brake is fully released.
WARNING
Driving with the brake system
warning light on is dangerous.
This indicates your brake system
may not be working ...
