Subaru Crosstrek Service Manual: Dtc u1120 lost communication with autostart stop control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULE
NOTE:
The electric power steering CM identifies whether the Auto Start Stop function is provided or not using information from the combination meter. Therefore, this DTC may be detected if lost communication with the combination meter occurs.
For the diagnostic procedure, refer to DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULE. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULE">
Dtc u0452 invalid data received from restraints control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0452 INVALID DATA RECEIVED FROM RESTRAINTS CONTROL MODULEDTC DETECTING CONDITION:Invalid data was transmitted ...
Dtc u1201 can-hs counter abnormal
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1201 CAN-HS COUNTER ABNORMALDTC DETECTING CONDITION:Communication is unstable because of high speed CAN commun ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSTALLATION1. Install the inhibitor switch to the transmission case temporarily.2. Connect the inhibitor harness connector to the inhibitor switch.3. Install the shifter arm and fix with the spring pin.NOTE:Use new spring pin.(A)Spring ...
Ignition control system
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureIGNITION CONTROL SYSTEMCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode">, and Inspection Mode Inspection Mode">.Wiring diagram:Engine electrical system Engine Elec ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyADJUSTMENT1. DIFFERENTIAL BEVEL PINION GEAR BACKLASH1. Disassemble the front differential assembly. Front Differential Assembly > DISASSEMBLY">2. Select the adjusting washer from the table and install.Adjusting was ...
