Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0101 lost communication with tcm
- Dtc u0073 control module communication bus off
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc b2300 rear radar circuit low
- Dtc b2301 rear radar circuit high
- Dtc b2304 rear radar on-off switch stuck
- Dtc b2311 rear radar detect tcm
- Dtc b2313 rear radar detect vdc
- Dtc b2327 rear radar internal failure (internal electric circuit)
- Dtc b2329 rear radar axis alignment incomplete
- Dtc b2350 rear radar communication error between master and slave
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0402 invalid data received from tcm
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0422 invalid data received from body control module
- Dtc u0423 invalid data received from instrument panel cluster control module
Wiring diagram
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “BSD/RCTA System” in the wiring diagram. Blind Spot Detection/Rear Cross T ...
Dtc u0101 lost communication with tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not ar ...
Other materials:
Removal
IGNITION(H4DO) > Spark PlugREMOVALSpark plug:Refer to “SPECIFICATION” for spark plug. General Description > SPECIFICATION">1. RH SIDE1. Disconnect the ground cable from battery. NOTE">2. Remove the air cleaner case. Air Cleaner Case > REMOVAL">3. Disco ...
Installation
REAR SUSPENSION > Front Lateral LinkINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Before installation, inspect the following items and repl ...
Automatic engine shutdown
The remote engine start system will
automatically shut down or will not start
the engine under the following conditions.
The total run-time has exceeded 20
minutes.
Any door or the rear gate is opened.
The select lever is moved to any
position other than "P".
The engine hood is opene ...
