Subaru Crosstrek Service Manual: Dtc b2313 rear radar detect vdc

DTC DETECTING CONDITION:

Vehicle dynamics control (VDC) fails.

TROUBLE SYMPTOM:

• All functions of BSD/RCTA stop.

• Fail icon is displayed in the combination meter LCD display.

• Failure-related notification is displayed for approx. two seconds on LCD display in the combination meter.

• VDC warning light illuminates in the combination meter.

Check and replace the side that displayed the DTC.

1.CHECK VDC.

Check the VDC. Basic Diagnostic Procedure">

Is there any fault?

Perform the inspection according to the VDC diagnosis.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2313 REAR RADAR DETECT VDC">Go to Step 2.

2.CHECK BSD/RCTA.

1) Restore the vehicle to its original state.

2) Perform the Inspection Mode. Inspection Mode">

Is DTC B2313 displayed? (Current malfunction)

Replace the radar sensor. Radar Sensor">

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2311 rear radar detect tcm

Dtc b2327 rear radar internal failure (internal electric circuit)

Other materials:

Installation
EXTERIOR BODY PANELS > Rear GateINSTALLATION1. REAR GATE PANELCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. Install the hinge - rear gate to the vehicle body.2. Temporarily install the panel - rear gate to the hinge - rear ...

Dtc b19f1 open in front p/t 2 rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F1 OPEN IN FRONT P/T 2 RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is open.• Lap seat belt pretensioner (RH) is faulty.• Lap ...

Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the "ON" position then move the select lever to the "P" position with the select lever button pressed and brake pedal depressed. If the select lever does not move after performing the above procedure, perform the follo ...