Subaru Crosstrek Owners Manual: Date and time settings
The items in the date and time settings
can be set. To change the items, operate
the "
" or "
" switch.
NOTE
- The "Time/Date" item must be set to display the "Birthday", "Anniversary" and notifications for vehicle maintenance.
- The "Birthday" and "Anniversary" items can be entered after the "Date" item has been set
- Dates that do not exist in the Gregorian calendar cannot be set (for example, April 31).
- If your vehicle is equipped with genuine SUBARU navigation system, the clock of navigation system must be set separately.
- Preparation for date setting
- Current date and time setting
- Birthday setting
- Anniversary setting
- Clearing birthday or anniversary
- Daylight saving time setting
Selection screen
When the
button is pushed and held, the setting screen for each menu can be displayed.
Select the preferred menu by operating
the "
" or "
" switch.
Top menu
Menu opt ...
Preparation for date setting
Turn the ignition switch to the "ON"
position.
Push and hold the button to show
the selection screen.
After the selection screen is displayed,
operate the "
"
or "
...
Other materials:
Installation
EXTERIOR BODY PANELS > Rear DoorINSTALLATION1. REAR DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - rear door on it.2. Apply grease to the moving part of door hinges.3. Adjust the height by the jack, and temporarily install the panel assembly - rear door to the upper hing ...
Security indicator light
The security indicator light in the Subaru Ascent provides important information
regarding the status of both the alarm system and the immobilizer system, helping
to ensure vehicle security at all times.
Alarm system
This indicator blinks to inform the driver that the alarm system of the Subar ...
Inspection
GLASS/WINDOWS/MIRRORS > Remote Control Mirror SwitchINSPECTION1. Disconnect the connector of the switch - door mirror.2. Check the resistance between switch - door mirror terminals.Preparation tool:Circuit tester• Changeover switch RHTerminal No.Inspection conditionsStandard — OFF1 M? or ...
