Grease, wax, insects, or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the windshield washer or if the wiper operation is jerky, clean the outer surface of the windshield (or rear window) and the wiper blades using a sponge or soft cloth with a neutral detergent or mild-abrasive cleaner. After cleaning, rinse the windshield and wiper blades with clean water. The windshield is clean if beads do not form when you rinse the windshield with water.
CAUTION
If you cannot eliminate the streaking even after following this method, replace the wiper blades using the following procedures.
Windshield washer fluid
Windshield wiper blade assemblyRemoval
SECURITY AND LOCKS > Front Hood Lock AssemblyREMOVAL1. Open the front hood.2. Remove the clip, and remove the bracket - grille.NOTE:To prevent damage to the bracket - grille, make sure to remove all clips.3. Remove the lock assembly - front hood.(1) Remove the bolt and clip.(2) Disconnect the rel ...
Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...
Fog light switch
Headlight switch
Fog light switch
The front fog lights will turn on when the
fog light switch is placed in the "
"
position while the headlights are in the
following condition.
while the headlight switch is in the "
"
position
for models with the auto on/off h ...