Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Windshield washer fluid

Use windshield washer fluid. If windshield washer fluid is unavailable use clean water.

In areas where water freezes in winter, use an anti-freeze type windshield washer fluid. SUBARU Windshield Washer Fluid contains 58.5% methyl alcohol and 41.5% surfactant, by volume. Its freezing temperature varies according to how much it is diluted, as indicated in the following table.

In order to prevent freezing of washer fluid, check the freezing temperatures in the table above when adjusting the fluid concentration to the outside temperature.

If you fill the reservoir tank with a fluid with a different concentration from the one used previously, purge the old fluid from the piping between the reservoir tank and washer nozzles by operating the washer for a certain period of time. Otherwise, if the concentration of the fluid remaining in the piping is too low for the outside temperature, it may freeze and block the nozzles.

CAUTION

Adding the windshield washer fluid
CAUTION Never use engine coolant as washer fluid because it could cause paint damage. Remove the washer tank filler cap, then add windshield washer fluid until it reaches the "FULL" mark on ...

Replacement of wiper blades
Grease, wax, insects, or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the winds ...

Other materials:

Dtc c0033 fl hold valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0033 FL HOLD VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...

Dtc c1542 clutch switch on malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1542 CLUTCH SWITCH ON MALFUNCTIONDTC detecting condition:Abnormal clutch signalTrouble symptom:Hill start assist does not operate.NOTE:Depending on the user clutch operation patterns, the hi ...

Service diagnostics mode Operation
ENTERTAINMENT > Service Diagnostics ModeOPERATIONNOTE:Installed only to model with 7 inch display.1. PROCEDURE TO SWITCH TO SERVICE DIAGNOSTICS MODE1. Turn the ignition switch to ACC.2. After turning the ignition switch to ACC and wait for 20 seconds or more, press the button (b) five times with ...

© 2016-2026 Copyright www.sucross.com