Subaru Crosstrek Owners Manual: Instruments and controls
- Ignition switch (models without "keyless access with push-button start system")
- Push-button ignition switch (models with push-button start system)
- Hazard warning flasher
- Meters and gauges
- Combination meter illumination
- Canceling the function for meter/gauge needle movement upon turning on the ignition switch
- Odometer
- Double trip meter
- Tachometer
- Fuel gauge
- ECO gauge (if equipped)
- Warning and indicator lights
- Initial illumination for system check
- Seatbelt warning light and chime
- SRS airbag system warning light
- Front passenger's frontal airbag ON and OFF indicators
- Check engine warning light/Malfunction indicator light
- Coolant temperature low indicator light/Coolant temperature high warning light
- Charge warning light
- Oil pressure warning light
- Engine low oil level warning light
- At oil temp warning light (CVT models)
- Low tire pressure warning light (U.S.-spec. models)
- ABS warning light
- Brake system warning light (red)
- Low fuel warning light
- Hill start assist warning light/Hill start assist OFF indicator light
- Door open warning light
- All-Wheel Drive warning light (CVT models)
- Power steering warning light
- Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light
- Vehicle Dynamics Control OFF indicator light
- Warning chimes and warning indicator of the keyless access with push-button start system (if equipped)
- Security indicator light
- Select lever/gear position indicator (CVT models)
- Cruise control indicator light (if equipped)
- Automatic headlight beam leveler warning light (models with HID headlights)
- Headlight indicator light
- Steering responsive fog lights warning indicator/ Steering responsive fog lights OFF indicator (models with EyeSight system)
- Information display (if equipped)
- Multi information display (models with type B combination meter)
- Multi function display (if equipped)
- Models without multi function display
- Features
- Locations
- Basic operation
- Welcome screen
- Date screen
- Ending screen
- Self-check screen
- Interruption screen
- Basic screens
- Selection screen
- Date and time settings
- Image quality and volume settings
- Screen settings
- Maintenance settings
- Driving history registration
- Car settings
- Initialize
- Light control switch
- Turn signal lever
- Illumination brightness control
- Headlight beam leveler (if equipped)
- Fog light switch
- Wiper and washer
- Mirrors
- Defogger and deicer
- Tilt/telescopic steering wheel
Sun shade
The sun shade can be slid forward or
backward by hand while the moonroof is
closed.
If the moonroof is opened, the sun shade
also moves back. ...
Ignition switch (models without "keyless access with push-button start
system")
WARNING
Never turn the ignition switch to
the "LOCK" position while the
vehicle is being driven or towed
because that will lock the steering
wheel, preventing steering
control. And when ...
Other materials:
Rear window wiper blade assembly
1. Raise the wiper arm off the rear
window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward
you to remove it from the wiper arm.
4. Install the wiper blade assembly to the
wiper arm. Make sure that it locks in place.
5. Hold the wiper arm ...
Dtc b1827 short in side airbag lh (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1827 SHORT IN SIDE AIRBAG LH (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (LH) circuit is shorted to ground.• Side airbag module (LH) is faulty.& ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Check the resistance between relay terminals.&bul ...