Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Automatic headlight beam leveler warning light (models with HID headlights)

Subaru Crosstrek Owners Manual / Instruments and controls / Warning and indicator lights / Automatic headlight beam leveler warning light (models with HID headlights)

This light illuminates when the automatic headlight beam leveler does not operate normally.

If this light illuminates while driving or does not turn off approximately 3 seconds after turning the ignition switch to the "ON" position, have your vehicle inspected at your SUBARU dealer.

Front fog light indicator light

This indicator light illuminates while the front fog lights are illuminated.

Cruise control indicator light (if equipped)
This light illuminates when the cruise control main button is pressed to activate the cruise control function. For details, refer to "To set cruise control" CAUTION If the CHECK ENGINE warnin ...

Headlight indicator light
This indicator light illuminates under the following conditions. when the light switch is turned to the " " or " " position when the light control switch is in the "AUTO" posit ...

Other materials:

Dtc u0155 lost communication with instrument panel cluster (ipc) control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULEDTC DETECTING CONDITION:No data is received from combination meter.TROUBLE SYMPTOM:Display of combination meter does not operate properl ...

Disassembly
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelDISASSEMBLY1. CROSSTREK MODEL1. Remove the screw, disconnect the connector and remove the paddle shift switch. (Model with paddle shift)2. Release the claws and remove the screws, then detach the cover - spoke.3. Remove connector and screw, a ...

Dtc p0340 camshaft position sensor "a" circuit bank 1 or single sensor
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0340 CAMSHAFT POSITION SENSOR "A" CIRCUIT BANK 1 OR SINGLE SENSORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION ...

© 2016-2020 Copyright www.sucross.com