Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Wheel balance

Each wheel was correctly balanced when your vehicle was new, but the wheels will become unbalanced as the tires become worn during use. Wheel imbalance causes the steering wheel to vibrate slightly at certain vehicle speeds and detracts from the vehicle's straight-line stability. It can also cause steering and suspension system problems and abnormal tire wear. If you suspect that the wheels are not correctly balanced, have them checked and adjusted by your SUBARU dealer.

Also have them adjusted after tire repairs and after tire rotation.

CAUTION

Loss of correct wheel alignment causes the tires to wear on one side and reduces the vehicle's running stability. Contact your SUBARU dealer if you notice abnormal tire wear.

NOTE

The suspension system is designed to hold each wheel at a certain alignment (relative to the other wheels and to the road) for optimum straight-line stability and cornering performance.

Tire pressures and wear
Maintaining the correct tire pressures helps to maximize the tires' service lives and is essential for good running performance. Check and, if necessary, adjust the pressure of each tire (includ ...

Wear indicators
New tread Worn tread Tread wear indicator Each tire incorporates a tread wear indicator, which becomes visible when the depth of the tread grooves decreases to 0.063 in (1.6 mm). A ti ...

Other materials:

Removal
SECURITY AND LOCKS > Impact SensorREMOVAL1. Pull out the key from the ignition switch, or turn off the power.2. Close all the doors and rear gate.3. Press the UNLOCK button of the keyless transmitter or access key.4. Disconnect the ground cable from battery. NOTE">5. Remove the impact se ...

Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR PipeINSTALLATION1. Temporarily install the EGR pipe to the intake manifold and water pipe assembly, and tighten the EGR pipe in numerical order as shown in the figure.NOTE:Use a new gasket.Tightening torque:6.4 N·m (0.7 kgf-m, 4. ...

Removal
LIGHTING SYSTEM > Tail/Stop Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combinatio ...

© 2016-2026 Copyright www.sucross.com