Subaru Crosstrek Service Manual: Specification
CLUTCH SYSTEM > General Description
SPECIFICATION
Model | 2.0 L | ||
Transmission type | 5MT | ||
Clutch cover | Type | Push type | |
Diaphragm set load | N (kgf, lbf) | 5,688 (580, 1,279) | |
Clutch disc | Facing material | Woven (non-asbestos) | |
O.D. ? I.D. ? Thickness mm (in) | Flywheel side | 225 ? 150 ? 3.2 (8.86 ? 5.9 ? 0.126) | |
Clutch cover side | 225 ? 150 ? 3.5 (8.86 ? 5.9 ? 0.138) | ||
Spline outer diameter | mm (in) | 25.2 (0.992), (number of teeth: 24) | |
Depth of rivet head mm (in) | Flywheel side | 1.35 — 1.95 (0.053 — 0.077) | |
Clutch cover side | 1.65 — 2.25 (0.065 — 0.089) | ||
Limit of sinking | 0.8 (0.031) | ||
Deflection limit | mm (in) | 0.7 (0.028) at R = 110 (4.33) | |
Clutch release lever ratio | 1.6 | ||
Release bearing | Grease-packed self-aligning | ||
Clutch pedal | Full stroke | mm (in) | 130 — 135 (5.12 — 5.31) |
Free play | mm (in) | 4 — 11 (0.16 — 0.43) | |
Flywheel | Type | Flexible | |
Caution
CLUTCH SYSTEM > General DescriptionCAUTION• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled parts in order and prot ...
Component
CLUTCH SYSTEM > General DescriptionCOMPONENT1. CLUTCH ASSEMBLY(1)Dust cover(6)Release bearingTightening torque: N·m (kgf-m, ft-lb)(2)Lever spring(7)Clutch coverT1:16 (1.6, 11.8)(3)Pivot(8)Cl ...
Other materials:
Engine exhaust gas (carbon monoxide)
WARNING
Never inhale exhaust fumes from your Subaru Ascent.
Exhaust gases contain carbon monoxide, an invisible and odorless gas that
can cause serious injury or death if inhaled.
Regularly inspect and maintain the exhaust system to prevent gases from
entering the cabin.
Never ...
Electrical specification
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONTerminal No.ContentMeasured value and measuring conditionsRemarks1 — — — 2 — — — 3 — — — 4Ignition power supply10 — 13 V (when the ignition switch is ON) — 5GND0 V (always) ...
Inspection
MECHANICAL(H4DO) > Cylinder HeadINSPECTION1. CYLINDER HEAD1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no marks of gas leaking or water leaking on gasket ...
