Subaru Crosstrek Service Manual: Caution
CLUTCH SYSTEM > General Description
CAUTION
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Apply grease onto sliding or revolving surfaces before installation.
• Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.
• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.
• Keep fluid away from the vehicle body. If any fluid contacts the vehicle body, immediately flush the area with water.
Specification
CLUTCH SYSTEM > General DescriptionSPECIFICATIONModel2.0 LTransmission type5MTClutch coverTypePush typeDiaphragm set loadN (kgf, lbf)5,688 (580, 1,279)Clutch discFacing materialWoven (non-asbestos) ...
Other materials:
Installation
EXTERIOR/INTERIOR TRIM > Roof SpoilerINSTALLATIONCAUTION:• Make sure that packings are attached on the clips of the roof spoiler assembly. If a gasket is not attached, water leakage may occur.• Make sure the bolt is tightened securely because improper installation may cause the water ...
Dtc b228a engine speed signal(with auto start stop)
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B228A ENGINE SPEED SIGNAL(WITH Auto Start Stop)DTC detecting condition:When the engine speed signal transmitted from the ECM via solid line and the engine speed signal transmitt ...
Preparation tool
LUBRICATION(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS18332AA000OIL FILTER WRENCHUsed for removing and installing oil filter (black). (Outer diameter: 68 mm (2.68 in)) — SUBARU SELECT MONITOR 4Used for setting of each function and trouble ...
