Subaru Crosstrek Service Manual: Preparation tool
LUBRICATION(H4DO) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
18332AA000
OIL FILTER WRENCH
Used for removing and installing oil filter (black). (Outer diameter: 68 mm (2.68 in))
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Oil filter wrench (65/67 mm 14 Flutes) | Used for removing and installing oil filter (blue). (Outer diameter: 67.4 mm (2.65 in)) |
Circuit tester | Used for measuring resistance, voltage and current. |
DST-i | Used together with Subaru Select Monitor 4. |
TORX® bit T45 | Used for removing and installing oil pan upper. |
Component
LUBRICATION(H4DO) > General DescriptionCOMPONENT1. OIL PAN AND STRAINER(1)Oil pan upper(8)Drain plug gasketTightening torque: N·m (kgf-m, ft-lb)(2)O-ring(9)Drain plugT1:5 (0.5, 3.7)(3)Baffle ...
Oil level switch
...
Other materials:
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 12 (+) — No. 42 (−):(A)+ probe(B)− probe3 ...
Dtc p0500 vehicle speed sensor "a" circuit
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0500 VEHICLE SPEED SENSOR "A" CIRCUITDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:VDC does not operate.STEPCHECKYESNO1.CHECK DTC.Read the DTC of VDC ...
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 seconds.
If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnecte ...
