
1. Open the key head using a flat-head screwdriver.

2. Remove the transmitter case from the key head.

3. Open the transmitter case by releasing the hooks.

1) Negative (−) side facing up
4. Replace the old battery with a new battery (type CR1620 or equivalent) making sure to install the new battery with the negative (−) side facing up.
5. Put together the transmitter case by fitting the hooks on the case.
6. Reinstall the transmitter case in the key head.
7. Refit the removed half of the key head.
After the battery is replaced, the transmitter
must be synchronized with the
remote keyless entry system's control
unit. Press either the "
" or "
" button
six times to synchronize the unit.
Replacing battery of access key
SpecificationsInstallation of child restraint systems by use of lower and tether
anchorages (LATCH)
WARNING
Child restraint systems and seatbelts
can become hot in a vehicle
that has been closed up in sunny
weather; they could burn a small
child. Check the child restraint
system before you place a child
in it.
Do not leave an unsecured child
restraint system in your vehicle.
...
Installation
EXTERIOR/INTERIOR TRIM > Cowl PanelINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the cowl panel assembly.CAUTION:If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The ...
Dtc c1432 different ecu specifications
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1432 DIFFERENT ECU SPECIFICATIONSNOTE:For the diagnostic procedure, refer to “DTC C1423 DIFFERENT ECU SPECIFICATIONS”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) &g ...