Subaru Crosstrek Owners Manual: Replacing battery of access key
CAUTION
When removing or reinstalling the access key cover, make sure that the plastic part does not come off or become misaligned.
Battery: Button battery CR2032
- Release button
- Mechanical key
1. Take out the mechanical key.
2. Wrap a flat-head screwdriver with vinyl tape or a cloth, and insert it in the gap to remove the cover.
3. Take out the battery using a flat-head screwdriver with vinyl tape or a cloth.
4. Insert a new battery with its positive (+) side facing upward as shown in the figure.
5. Attach the cover to the access key by fitting the projections and recesses together.
Safety precautions
CAUTION
Do not let dust, oil or water get on
or in the access key/transmitter
when replacing battery.
Be careful not to touch or damage
the printed circuit board in
the access key/transm ...
Replacing transmitter battery
1. Open the key head using a flat-head
screwdriver.
2. Remove the transmitter case from the
key head.
3. Open the transmitter case by releasing
the hooks.
1) Negative (−) s ...
Other materials:
Dtc p2009 tgv control circuit low bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2009 TGV CONTROL CIRCUIT LOW BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION"& ...
Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTION1. BASIC INSPECTIONBefore performing the diagnosis, check the following items which may cause problems relating the wiper or light.1. Check the battery. Battery">2. Check the relay and fuse condition. Relay ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSTALLATION1. Install the inhibitor switch to the transmission case temporarily.2. Connect the inhibitor harness connector to the inhibitor switch.3. Install the shifter arm and fix with the spring pin.NOTE:Use new spring pin.(A)Spring ...
