Subaru Crosstrek Owners Manual: Safety precautions
CAUTION
- Do not let dust, oil or water get on or in the access key/transmitter when replacing battery.
- Be careful not to touch or damage the printed circuit board in the access key/transmitter when replacing the battery.
- Be careful not to allow children to touch the battery and any removed parts; children could swallow them.
- There is a danger of an explosion
if the battery is incorrectly replaced.
Replace only with the same or equivalent type of the battery.
- Batteries should not be exposed to excessive heat such as bright sunlight, fire or the like.
NOTE
- Replace only with the same or equivalent type of battery recommended by the manufacturer.
- Dispose of used batteries according to local laws
- Mount the battery in the correct
orientation to prevent fluid leakage.
Be careful not to bend the terminals. It may result in a malfunction.
- It is recommended that the battery be replaced by a SUBARU dealer.
- Use a new battery.
- After replacing the battery, confirm that the transmitter functions properly.
Replacing key battery
The access key / transmitter battery may
be discharged under the following conditions.
The operation of the keyless access
function is unstable
The operating distance of the remote
keyless ...
Replacing battery of access key
CAUTION
When removing or reinstalling the
access key cover, make sure that
the plastic part does not come off or
become misaligned.
Battery: Button battery CR2032
Release button
Mechani ...
Other materials:
Dtc p0453 evap system (cpc) pressure sensor/switch circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0453 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mod ...
Clear memory mode Operation
BODY CONTROL SYSTEM (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, selec ...
Note
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemNOTEFor procedure of each component of the wiper and washer system, refer to the respective sections.• Combination switch (wiper): Combination Switch (Wiper)">• Wiper blade: Wiper Blade">• Front wiper arm: Fron ...
