Subaru Crosstrek Service Manual: Installation

1. Install the O-ring.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-ring.

2. Install the plate and the oil pump.

NOTE:

Apply CVTF to the bolt.

Tightening torque:

8.5 N·m (0.9 kgf-m, 6.3 ft-lb)

3. Install the oil pump chain cover. Oil Pump Chain > INSTALLATION">

4. Install the torque converter assembly. Torque Converter Assembly > INSTALLATION">

5. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Removal

Oil pump chain

Other materials:

Lock
The key can only be inserted or removed in this position. The ignition switch will lock the steering wheel when you remove the key. If turning the key is difficult, turn the steering wheel slightly to the right and left as you turn the key. The key can be turned from the "ACC" to "LOCK" ...

Ignition switch (models without "keyless access with push-button start system")
WARNING Never turn the ignition switch to the "LOCK" position while the vehicle is being driven or towed because that will lock the steering wheel, preventing steering control. And when the engine is turned off, it takes a much greater effort than usual to steer. Before leaving t ...

Removal
BRAKE > Brake PedalREMOVAL1. CVT MODELCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait fo ...