Subaru Crosstrek Service Manual: General description

Installation

CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the ...

Caution

CLUTCH SYSTEM > General DescriptionCAUTION• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled parts in order and prot ...

Other materials:

Installation
PARKING BRAKE > Parking Brake CableINSTALLATION1. Install each part in the reverse order of removal.Tightening torque:Cable clamp: 18 N·m (1.84 kgf-m, 13.3 ft-lb)Rear wheel: Except for C4 model120 N·m (12.24 kgf-m, 88.5 ft-lb)Rear wheel: C4 model100 N·m (10.20 kgf-m, 73.8 ft- ...

Replacement
CLUTCH SYSTEM > Clutch FluidREPLACEMENTCAUTION:• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.• Use new FMVSS No. 116 DOT3 or DOT4.• Cover the air bleeder wi ...

Disassembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the hub ...