Subaru Crosstrek Service Manual: Preparation tool
CLUTCH SYSTEM > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
498497100
CRANKSHAFT STOPPER
Used for stopping rotation of the flywheel.
499747100
CLUTCH DISC GUIDE
Used for installing the clutch disc to the flywheel.
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
Dial gauge | Used for measuring clutch disc run-out. |
Depth gauge | Used for measuring clutch disc wear. |
Angle gauge | Used for tightening the flywheel. |
DST-i | Used together with Subaru Select Monitor 4. |
Component
CLUTCH SYSTEM > General DescriptionCOMPONENT1. CLUTCH ASSEMBLY(1)Dust cover(6)Release bearingTightening torque: N·m (kgf-m, ft-lb)(2)Lever spring(7)Clutch coverT1:16 (1.6, 11.8)(3)Pivot(8)Cl ...
Master cylinder
...
Other materials:
Installation
REAR SUSPENSION > Rear Lateral LinkINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Before installation, inspect the following items and repla ...
Double trip meter
Type A
Trip knob
Type B
Trip knob (U.S.-spec. models)
Trip knob (except U.S.-spec. models)
This meter displays the two trip meters
when the ignition switch is in the "ON"
position.
The trip meter shows the distance that the
vehicle has been driven since you last set
it to ...
Inspection
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof SwitchINSPECTION1. Check the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnector1 — 3OpenLess than 1 ?(b): Slide switch4 — 3CloseLess than 1 ?1 — 3Tilt upLess than 1 ?(a): ...
