Subaru Crosstrek Service Manual: Rear oxygen sensor

Installation

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSTALLATIONInstall in the reverse order of removal.NOTE:• Use new O-rings.• Apply engine oil to O-ring.Tightening torque:6.4 N ...

Inspection

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Rear Oxygen SensorINSPECTION1. Check that the rear oxygen sensor has no deformation, cracks or other damages.2. Measure the resistance between rear oxygen sens ...

Other materials:

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3. ...

Dtc p2401 evap system leak detection pump control circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2401 EVAP SYSTEM LEAK DETECTION PUMP CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...

Electrical specification
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONTerminal No.ContentMeasured value and measuring conditionsRemarks1 — — — 2 — — — 3 — — — 4Ignition power supply10 — 13 V (when the ignition switch is ON) — 5GND0 V (always) ...