Subaru Crosstrek Service Manual: Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control Solenoid
INSTALLATION
Install in the reverse order of removal.
NOTE:
• Use new O-rings.
• Apply engine oil to O-ring.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causin ...
Other materials:
Caution
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General DescriptionCAUTION1. SUPPLEMENTAL RESTRAINT SYSTEM “AIRBAG”Airbag system wiring harness is routed near the TPM control module.CAUTION:• Do not use electrical test equipment on any of the airbag system wiring harness circuit ...
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseDISASSEMBLY1. Remove the oil stopper plate.2. Remove all plugs from the transmission case.3. Remove the oil seal using a screwdriver wrapped with cloth etc.4. Using the ST, remove the ball bearing of the secondary pulley.(1) Remove the ...
Removal
CONTROL SYSTEMS > Select CableREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.3. Lift up the vehicle.4. Remove the center exhaust pipe. Cen ...
