Subaru Crosstrek Owners Manual: Operating the driver's window
- Automatically open/close
- Open/close
To open: Push the switch down lightly and hold it.
The window will open as long as the switch is held.
This switch also has a one-touch auto down function. To open the window fully, push the switch down until it clicks and then release it. To stop the window halfway, pull the switch up lightly.
To close: Pull the switch up lightly and hold it. The window will close as long as the switch is held.
This switch also has a one-touch auto up function. To close the window fully, pull the switch up until it clicks and then release it.
To stop the window halfway, push the switch down lightly.
NOTE
If the vehicle's battery is disconnected due to situations such as battery or fuse replacement, the onetouch auto up/down function will be deactivated. Initialize the power window to reactivate the one-touch auto up/down function. Refer to "Initialization of power window" 2-37.
When the following operations are performed, the power window breaker will operate and it may not be possible to open or close the window.
- After the driver's window is fully closed or fully opened, the switch is continuously operated in the same direction for a few seconds.
- After the windows for three or more seats are fully closed or fully opened, each switch is continuously operated in the same direction simultaneously for a few seconds.
In this case, after the breaker recovers, be sure to initialize the power windows.
If they are not initialized, the one-touch auto up/down function will not operate.
Refer to "Initialization of power window" 2-37.
Driver's side power window switches
Lock switch
For driver's window (with one-touch auto
up and down feature)
For front passenger's window
For rear left window
For rear right window
All door windows can be controlled ...
Anti-entrapment function
CAUTION
Never attempt to test this function
using fingers, hands or other
parts of your body.
The anti-entrapment function
may not operate properly if some
object gets trapped just befor ...
Other materials:
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > FRESH/RECIRC Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the FRESH/RECIRC switch to check that the link operates normally.3. If it does not operate normally as t ...
Installation
FRONT SUSPENSION > Front CrossmemberINSTALLATION1. Check the crossmember for damage or cracks, and correct or replace if defective.2. Install the universal joint assembly - steering. Universal Joint > INSTALLATION">3. Install each part in the reverse order of removal.CAUTION:• U ...
Cruise control command switch
Installation
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do no ...
