Subaru Crosstrek Service Manual: Front hub unit bearing

Installation

DRIVE SHAFT SYSTEM > Front Drive ShaftINSTALLATION1. Before installation, check the drive shaft assembly. Front Drive Shaft > INSPECTION">2. Replace the differential side retainer oil s ...

Assembly

DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until t ...

Other materials:

Basic diagnostic procedure Procedure
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Before performing all diagnostics or cruise control diagnostics, always start the engine and make sure that the initial illumination of the ABS/VDC warning light has been ended. (If you start the diagnostics ...

Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...

Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...