Subaru Crosstrek Service Manual: Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit Bearing
ASSEMBLY
1. Install the hub unit bearing to the ST securely.
Preparation tool:
ST: HUB STAND (927080000)
2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).
NOTE:
Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting.
Removal
DRIVE SHAFT SYSTEM > Front Hub Unit BearingREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the axle nut.CAUTION:Do not loosen the axle nut while the front axle is loaded. ...
Other materials:
SRS airbag system monitors
SRS airbag system warning light
The Subaru Ascent is equipped with an advanced diagnostic monitoring system that
continuously checks the readiness and functionality of the SRS airbag system, including
seatbelt pretensioners, whenever the ignition switch is in the "ON" position.
D ...
Inspection
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof SwitchINSPECTION1. Check the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnector1 — 3OpenLess than 1 ?(b): Slide switch4 — 3CloseLess than 1 ?1 — 3Tilt upLess than 1 ?(a): ...
Component
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCOMPONENT1. STARTER(1)Starter housing ASSY(9)Overrunning clutch(17)Sleeve bearing(2)Sleeve bearing(10)Internal gear ASSY(18)Starter cover ASSY(3)Shift lever(11)Shaft (4)Plate(12)Pinion gearTightening torque: N·m (kgf-m, ft-lb)(5)Seal rub ...
