Subaru Crosstrek Owners Manual: Access key - if access key does not operate properly
CAUTION
Keep metallic objects, magnetic sources and signal transmitters away from the area between the access key and the push-button ignition switch. They may interfere with the communication between the access key and the push-button ignition switch.
The following functions may be inoperable because of strong radio signals in the surrounding area or the access key battery being low.
- Locking/unlocking doors (including the rear gate)
- Switching power status
- Starting engine
In such cases, perform the following procedure. When the battery of the access key is discharged, replace it with a new one. Refer to "Replacing battery of access key" F11-42.
Towing with all wheels on the ground
1. Release the parking brake and put the
transmission in the "N" position.
2. The ignition switch should be in the
"ON" position while the vehicle is being
towed.
3. Take up slack in the ...
Locking and unlocking
Release button
Mechanical key
While pressing the release button of the
access key, take out the mechanical key.
Lock or unlock the driver's door with the
mechanical key in the procedu ...
Other materials:
Dtc b14e5 mode door actuator stepping motor circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E5 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPENDTC detecting condition:Mode door actuator stepping motor circuit is open.Trouble symptom:Vent does not change.Wiring diagram:Air conditioning syst ...
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated as the new
set speed.
U.S.-spec. models
When the difference between the actual
vehicle speed and ...
Component
WHEEL AND TIRE SYSTEM > General DescriptionCOMPONENT(1)Screw(4)TPMS & keyless entry control moduleTightening torque: N·m (kgf-m, ft-lb)(2)Transmitter (snap in type)(5)TPMS CMT1:1.4 (0.14, 1.0)(3)Valve T2:7.5 (0.76, 5.5) T3:13 (1.33, 9.6)(1)TPMS & keyless entry control module(2) ...
